Does anyone know where the fuses and/or relays are for headlights on an 85 Cutlass...?
According the Chilton's I have the fuse box is located down by the pedals on the driver's side (I already knew that) but then the book says refer to the panel on the fuse box door for individual fuse...
Thanks!
Naw...I'm not replacing the chrome trim around the bumpers...
The only chrome I'm looking to replace are the wheel fender pieces and the pieces that go along the edge of the door. Hopefully I can find some in decent condition...
I actually like the straight pinstripe. I didn't...
Thank you for the compliment as well...
I think the door trim will look nice as well, I just haven't had any luck finding the pieces in good condition...
Thanks for the compliment...
Not the lower molding...
I was talking about the vertical molding that goes on the edge of the door...
You can see it in the before picture...
Thanks for saying so...
I didn't include pictures of the inside because the inside is trashed...lol...
I have a bunch of junk in there from all the work I've done on the car up to this point, old receipts, boxes from new parts, a transmission pan gasket, etc...and I have a makeshift...
It's no problem...none at all...I like pinstripes and with all the other detailing I removed from the car I didn't want to include the pinstripe...
It's just personal preference...
Oh wow...
I have a t-top Cutlass so I have an idea of what that is supposed to look like...
What kind of parts are you looking for?
I would think that you'd need to see a body shop to rectify the situation in those pictures. My doors looked a lot like that and the local body shops...
You're right...
I'm really impressed with the job the painter did as far as his paint matching/selection...
I'll have to take some pics from different angles to see if I can catch the pearl flakes...
Thanks for the compliments, guys...
I'm actually going to see if I can replace the chrome door trim and the wheel fender chrome with some fresher pieces...
After the body work was done the old pieces wouldn't fit back on because they were bent...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.