Search results

Ok will do is there any major places I should clean out and check. I'm going to clean the whole oil pan and is there any way to flush it?

O ok I have a summit cam that is steel

I'll post a pic tonight but it was a msd dizzy

Have a quick question. What are most distributor gears made of? Jumped timing last night and it ate the teeth off of the distributor and seeing the easiest way to get all the shavings out.

I traded a set of used 1977 lt-1 heads. Who got the better deal?

Just got a set of dz 302 heads and I'm trying to find out if they're worth anything.

Forgot to mention that its going in my 87 cutlass

I have a 2600 stall converter and I have a set of 3.73 for it but wasn't sure which was better.

Looking to see what I can do to try and get into the 12s Have a 350 bored .060 over with hypertonic pistons has scat rotating assembly with 1.94 heads just stock slightly port have a summit cam its .488 / .510 not sure of any other specs. Have the torker II intake with a holley 750 vac...

Well I figured out last night if you hold the brake pedal it with the flashers on that they stay solid then when you let off the go away so is there something in the brake switch? And good pic ill check that tonight

my turn signals work and so do my brake lights so what would i check next

Well the only thing stopping me from getting plates on my car is the hazards. The blinkers work fine along with all other lights but the only thing that doesn't work are the hazards. How can I get them to work or where is the relay looked all under the dash but all I can find is the one for the...

Now i have a different problem lol can't find how to fix the hazards or where the fuse is

just want to say thanks to all for the help. went back through and checked every little thing it ended up being the cap. it had some corrosion on the points so i sanded it all off now the car runs great beside the little rocker tick but im getting around to that. thanks again for all the help

Yea wires are good along with the degree would a bad coil still give it spark but not enough to make it run

It's on time only about 2 degrees off. It will kinda run off of starting fluid

This motor is on my last nerve. What I have is a small block 350 bored .060 over with flat top hypertonic pistons I-beam rods and crank .010 under. Has a torker II intake and a holley 750 vacuum secondary. And just a regular hei distributor. The problem is that it won't run. I think I've tried...

I think what happened is that I didn't ground the block

So I put a built 350 in my cutlass and I need some help on the starter wiring. Thought I had it right but when I put my + terminal on it started to arc and melt the wires. I have the positive cable to the alt and the starter. Can you tell me what wires need to go to the starter