4 SPD Saginaw tail housing
- Thread starter KYMalibu
- Start date
- Status
That's the right set up! Good for you. Now all you need is a tail housing. Since you need to separate the tail from the main case anyway, why not freshen it up with a rebuild kit? Or has that been done? Nothing like fresh synchonizers and bearings.
O
I called Hurst direct . They don't make that set up anymore since 2012 could hook me up for 600.00 !!!
O
I called Hurst direct . They don't make that set up anymore since 2012 could hook me up for 600.00 !!!
On top of that had to buy the correct shifter rod for an additional $ 85.00
Haha I just got the Hurst mounting plate and rod kit and waited and searched on eBay for the correct shifter. Paid about half price for it, just was listed for a different car. Hurst Shuster's fit a wide range of applications and a lot of part #s interchange from different manufacturers. The ONLY thing I am missing from this whole swap is the stick. Even those go for some outrageous prices. Good Luck on your swap! I'm so giddy to get mine done, but I'm taking my time and being patient. The TH200 in it right now was doing fine when I drove to and from work today.
So I'll wait a little longer and enjoy driving it.
So I'll wait a little longer and enjoy driving it.
Now anyone got a
Awesome Bro , but this isn't a swap ! Original 4 SPD car and it is an absolute nightmare to get parts . Everything was fine until I got to the trans parts . But hey it's my toy and just like like everything in else in life that you enjoy , there's bound to be frustration.
If all you can find is a later model meant for a torque tube equipped car that is missing holes, that is what I used. Go back up to the picture with the open floor. See the "C" clamp that goes from the top mount hole to the lowest housing hole? It is how I made this type tail work. http://www.ebay.com/itm/290996279996?_trksid=p2060353.m1438.l2649&ssPageName=STRK:MEBIDX:IT
- Status
Similar threads
