Aftermarket buckets and a monte console with the shift plate trimmed to fit the Hurst shifter. The car is torn apart right now, but it will match when done.
View attachment 78589
View attachment 78590
Those look Comfy! Looks really good too, stock console looks sharp.
I installed Cerullo buckets on GM power tracks and modified a 78' Trans Am center console to fit.
They also make a manual version of the console.
That looks super nice! Nice attention to the small details, I like where you mounted your switches too.
Old Malibu with a T-5
Current Malibu with a T-56
I like this! Very stealthy! Which shifter location on the trans are you using for that position? I wasnt sure if I need to have th F body location or the forward mount???
I'm curious to see what everyone else has done, mine has an
Impala console in it that the builder put in. I purchased a fifth gen camaro console to go in when I do the engine and manual transmission swap but that seems to keep getting further and further away.
View attachment 78591
How do you find the height of the armrest on that console? That looks like about the same height as a S-10 Blazer console and they are common as heck around here.
Can always go stock.
View attachment 78603
Unfortunately I doubt I will find a nice enough stock unit, unless I get really, really lucky.
I am kinda eyeing some E48 and E36 BMW seats I have seen on Kijiji. I don't know why but BMW and Subaru Seats are common as dirt in my neck of the woods. 6 way power and heated would be nice in the cold we get in the fall and winter. If I am going to do some mount fabrication I should make it worth it. I am looking for later model Grande Prix GTP leather seats, seen those installed and they look NICE!