Ok, I got my hands on a damn near new Edelbrock Performer EPS for cheap...
Intake Manifold Installation 305 SBC
- Thread starter Tynan918
- Start date
- Status
Question is, I installed the Performer RPM not too long ago and the gaskets are still in good shape and match what I'm putting on...can I reuse these gaskets...?
And before I put it on, should I clean the pushrods and lifters ?
And before I put it on, should I clean the pushrods and lifters ?
What's wrong with using the same gasket ?
Really not that much wear and tear that I can visually see...
New gaskets, clean surface areas, prevent debris from going into crankcase. Change oil more often with the right oil. Go synthetic or a 10w-30 or so.
the gaskets compress over time(short time) and it's a gamble to reuse them.they're not expensive so it's cheap insurance to change them.Axisg mentioned the term china wall,the new gaskets come with two rubber strips like you currently have on the front of your block,they have a tendency with aluminum intakes to push out causing a decent oil leak,the china wall refers to a stout bead of rtv in place of those rubber gaskets.the bottom of your new intake shows what he's referring to.pick up a chiltion or a Hayes manual for your car,they're a good cheap resource.they cover a lot of procedures and it's solid info too.
Think im going to take my chances with the gaskets I have, they're not even 6 months old and less than 200 miles on them...
I plan on the oil change...have everything ready to go...
- Status
Similar threads
