LS to 4l80e flexplate and TC installation help

[Built6spdMCSS]

How did you a that hoist work in the snow?

Snow... welcome to Florida.

 

[Built6spdMCSS]

Besides, if you had snow, shovel out your spot and there ya go..

 

[johnnunez29]

Besides, if you had snow, shovel out your spot and there ya go..

where in florida? Im hoping to have a chance to get this done within the next few weeks, have a trip this weekend, next weekend my sons bday and mothers day. Bad timing to get engine back but very happy with the outcome. (look wise) hope it performs even better.

 

[johnnunez29]

where in florida? Im hoping to have a chance to get this done within the next few weeks, have a trip this weekend, next weekend my sons bday and mothers day. Bad timing to get engine back but very happy with the outcome. (look wise) hope it performs even better.

 

[Built6spdMCSS]

where in florida? Im hoping to have a chance to get this done within the next few weeks, have a trip this weekend, next weekend my sons bday and mothers day. Bad timing to get engine back but very happy with the outcome. (look wise) hope it performs even better.

Near the Fort Walton Beach & Destin area. Panhandle.

Yea, looks like shiny new parts.

 

[johnnunez29]

Near the Fort Walton Beach & Destin area. Panhandle.

Yea, looks like shiny new parts.

Cool. We took a drive up there a couple years ago woth boat in tow. To see an amazing area think it’s crab island. Well looked amazing in the videos. When we got there we found the worst damn fog ever. Almost the entire week we were there 🤦🏼‍♂️. It was beautiful in the clearer areas

 

[Built6spdMCSS]

Oh yea, Crab Island gets busy, I've been there a few times.

 

[johnnunez29]

Walmart.com is the cheapest I’ve found it - shows up in two days. And hold on for the volume. I have TruCool 40k cooler, with system empty it takes 4.2-4.4 gallons.

Jake has a video about marking your dipstick as well - search his vids on YT.

And FWIW, I’ve never put the engine and trans in preassembled. Too much of a PITA, and I have practice - between my sons car and mine I’ve pulled the motors more times than I have fingers. And if I’m motivated I can have the motor out in 3 hours. But normally 5hrs and a the better part of a 6 pack haha.

Close to 7/8 but this is without FP bolts torqued on at all. Have a bolt hole that I need to chase

 

[64nailhead]

Close to 7/8 but this is without FP bolts torqued on at all. Have a bolt hole that I need to chase

I see your flexplate has multiple mounting holes- do yourself a favor and mark the holes you’re going to use on the engine side.

And, ummm, ahhh, holy bejesus - Mast heads on a street car??? That thing is going to make 1000whp at 15psi.

I LOVE IT!!!!!!

 

[johnnunez29]

I see your flexplate has multiple mounting holes- do yourself a favor and mark the holes you’re going to use on the engine side.

And, ummm, ahhh, holy bejesus - Mast heads on a street car??? That thing is going to make 1000whp at 15psi.

I LOVE IT!!!!!!

Hoping for that 💪🏼💪🏼💪🏼