power steering pump need help will it fit???

[flamesoldier]

I have a 1987 Buick regal limited was a 3.8 v6 from factory. I dropped in a 1980-1985 350 4 bolt main. Will my power steering pump bolt up to block with proper brackets?? If not could i get a power steering pump from a 1980-1985 350 and will the lines fit my power steering gear box what is best for this???

 

[Blake442]

With the proper brackets, the pump will bolt up just fine.

 

[custom442]

Just line up the steering pump pulley with the others, use a string to help here. You can use your old bracket, might need to weld or bolt a longer piece onto it so it'll reach all the bolt holes, it's nbd

 

[1evilregal]

if it doesn't work, you could always try here: http://www.alangrovecomponents.com/index.htm

or get in touch with another member in here, fodoimp.... I bought a p/s bracket for my 327 from him, when my local speed shop said there wasn't a bracket available for it... fodoimp's link is: http://www.thestreetrodstore.com/


HTH...

darin

 

[anakputa]

I need the bracket that goes from the power pump to a/c bracket any ides what application might have this? I've checked the local yards here and come up short.

 

[1evilregal]

if you're not running the a/c compressor, why not eliminate the bracket? when I installed my headers, I didn't have enough clearance, and fodoimp set me up with this setup... the backside mounts back to the motormount bolt nicely... the one I have is part #400l on the page... http://www.alangrovecomponents.com/Smal ... t_Pump.htm

 

[anakputa]

Thanks, I am going to get this setup...