Thank you very much! I ordered up the sensors today. Actually worked out at the best possible time because I have to remove the copper tube from the hole it was in so I can install my clutch pedal assembly. Thanks a lot!
Temp Sensor/Oil Pressure Sensor for Engine Swap - OEM Gauges
- Thread starter RGBody87
- Start date
- Status
Thank you very much! I ordered up the sensors today. Actually worked out at the best possible time because I have to remove the copper tube from the hole it was in so I can install my clutch pedal assembly. Thanks a lot!
ACDELCO D8032 Oil Pressure Sender / Switch$ 29.99$ 0.001$ 29.99
STANDARD MOTOR PRODUCTS PS129T Oil Pressure Sender / Switch$ 5.15$ 0.001$ 5.15
STANDARD MOTOR PRODUCTS HP3840 Temperature Sender / Sensor Connector$ 5.31$ 0.001$ 5.31
STANDARD MOTOR PRODUCTS S939 Oil Pressure Sender / Switch Connector$ 5.92
STANDARD MOTOR PRODUCTS PS129T Oil Pressure Sender / Switch$ 5.15$ 0.001$ 5.15
STANDARD MOTOR PRODUCTS HP3840 Temperature Sender / Sensor Connector$ 5.31$ 0.001$ 5.31
STANDARD MOTOR PRODUCTS S939 Oil Pressure Sender / Switch Connector$ 5.92
I replaced the factory idiot light cluster with the factory idiot analog (mechanical) cluster. Gas gauge and volt meter work fine. The temp guage did work but the oil pressure guage has never read above 20-30 pounds even with the beand new engine in it. I assumed the printed circuit design would work with either setup but I'm ready to install after market guages in the car, Has anyone else gone through this? Would be nice to use the same instrument hole and mounting but don't know what to do about the printed circuit......
- Status
Similar threads
