I'm getting ready to slap some stock belts in the Monte and need 4 of them. Does the lap anchors, receivers, retractors, and pillar guides share the same bolt?
Torx bolts(seat belts)
- Thread starter Mr.Monte81
- Start date
- Status
Don't suppose you're located anywhere near Atlanta by chance? If so, I'd say you're welcome to swing by sometime and help yourself, grab a couple off a parts car here.
I believe there 3 or 4 different length bolts for the seatbelts. I know the B pillar bolts have the shoulder on them so the belt can pivot/move
ck80, I'm in Indiana. Cool, I wasn't sure if the B pillars were collared or had a sleeve. I'm sure I can get the regular t50's at Ace, then there's a couple yards about an hour out if Ace doesn't. Big 10-4 on anti sieze.
Seems like you should be able to get a set of good used bolts from a member on here. Shipping should be cheap. Start a thread in the 'wanted' section. There's lots of guys on here with parts and parts cars. That way you have the correct hardware.
Unfortunately, I'm not wrenching much (at all) lately until my neck and shoulder heal up some.
If you can't find any else where send me a PM down the line. If, and I should say when, I'm able to remove a set for you I'll send you a set if youre still in need. Might not be for a while though, likely a Christmas gift if I'm lucky.
I have grade 8 hex heads holding my 5 point harness in my Monte but I think for factory belts you would want a round head since a few of them pivot I think a hex might catch on the corners at times.
- Status
Similar threads
