Recent content by 67rstbkt

  1. 6

    Radio HELP ! 81 cutlass Calais

    The radio fuse(s) will be under the driver side dash. They should be labeled; you can narrow down the issue with a test light or multi meter. If you are unsure of which fuse to check, just turn the key on and touch a test light to both ends of every fuse - if you find any with power on one side...
  2. 6

    GP403's 87 Cutlass Supreme

    That's an awesome find! Thanks for saving another one!
  3. 6

    BUILD THREAD Grand prix LS1 build

    Opening comments for further content
  4. 6

    Should pink wire to distributor be 12v or higher?

    Yes, I saw it, but don't recall the Caprice. Did you get a new battery? Also, have you checked the voltage at the battery while cranking? And it is cranking, correct?
  5. 6

    Building a new shop from the ground up

    It sure does, I've got many years of that in my past.....makes my back hurt just thinking about it
  6. 6

    Building a new shop from the ground up

    Thanks, lol. If it makes you feel any better I haven't been able to work on my car for almost a year due to working on doing this :)
  7. 6

    Building a new shop from the ground up

    So pretty much wrapped up the rest of the stuff I wanted to get to in the shop. Air lines are complete and the lift has a removable cover.
  8. 6

    aftermarket carb swap

    Since all posts were not modified- I deleted the personal attacks. Let's keep it civilized folks :) If you don't have anything nice to say....you know the rest.
  9. 6

    Check this out !!

    I think he's looking for 30 dollars :)
  10. 6

    Building a new shop from the ground up

    I went with a 9' ceiling on mine as well. With my car, I can max out the lift and still have a little space between the roof and the ceiling. The total height of the lift at max height, not including the lift itself, is 48" - if it was not recessed into the floor and you drove over it, total...
  11. 6

    Building a new shop from the ground up

    The latest addition - towel dispenser/trash receptacle
  12. 6

    Building a new shop from the ground up

    thanks! The main drawback on this lift is that access to the transmission is limited, but with the space I have a 2 post would just be in the way. I might look into tall jack stands if I need to do transmission work. In the meantime, the next time I remove the transmission will be with the motor...
  13. 6

    Building a new shop from the ground up

    Trim paint done and got the car pushed in this weekend. Almost time to get back to work :)
  14. 6

    Building a new shop from the ground up

    Insulation is definitely a good thing - looking forward to seeing more on that Cutlass :)
  15. 6

    Building a new shop from the ground up

    I like the vent duct tape idea! I will do that on mine. Since I was having this built and they left it in studs, I just insulated the whole thing before I did the sheetrock. I lucked out on the heater - got that thing free from a good friend years ago. It sucks down power and I had to wire a...

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor