well, i got the transmission to the shop and they went through it, new seals, filter etc and they put it on their machine and everything checks out good...thats a plus. Only cost me $150 for that...plus they steam cleaned it so its nice and clean.
On the other hand...i started disassembling the motor...
OK, my B-day isn't until Aug. but my dad called me up last week and said he had an early b-day gift for me. Now he lives a few hours away and he told me to bring my truck so the wife and I drove up to Michigan to his house. Lo and behold, he had a Olds 350 with a TH400 transmission attached to it...
Thanks guys for the answers...lucky for me, I have a guy at work that used to own his own mechanics shop and knows the in's and out's of G-body motors. I already have another carb sitting in my garage that he's gonna rebuild for me, install and adjust it for me. I'm learning but I'm still pretty...
took the stick out and didn't get 100 yards before the motor started sputtering like crazy...put the stick and it drives fine under grandma type acceleration. Still bogs way down, almost to the stall point, under somewhat aggressive acceleration
So I took my 86 Cutlass Salon to the mechanic's yesterday because its been running really rough since the cold weather started in. Car/motor has 82k on the 307 and the previous owner removed the A.I.R./smog stuff. So after the mechanic looked it over, he determined that I probably have a few...
I know I'm asking alot, but could you give me a part number for that carb...i was gonna buy this one from summit
http://www.summitracing.com/parts/HLY-64-70092/
Well the other dilemma I would face is transmission....mine has the granny car TH200 Metric...I suspect it would not last long with a 350 or the 403. So I would have to swap trannys, and possibly driveshafts because of diferent lengths of the trannys. So now we are into more dollars than i...
Gonna go with the 83 307 and an Edelbrock EDL-3711 intake, new carb, and I'll be going headers because I don't have the original exhaust manifolds from the 83. Gona stick with the CC carb and distributor for now.
i really wanted an olds 350 but I have around $4k to spend total on the car. I need the brakes redone, some suspension componants, etc. I'm not a "performance" oriented guy, and I already have the other 307, so it made the most sense from a finance standpoint.
thanks, I'm thinking I'll just grab up an Edelbrock intake then. This is gonna save me alot of time on the rebuild, instead of having them rebuild the engine thats currently in the car.
So I have my 86 Salon that needs some engine work and I also have a 307 out of an 83 delta that I could save myself some time by having it rebuilt while i'm driving the car still. I know there is a difference in the heads but could I take the block, internals and the heads on the 83 and drop...
Well I just decided to go in blind, since the manual is very generic. First thing I did was spray everything down under the car with Engine Degreaser last night. This helped get rid of a bunch of gunky buildup under there. So the starter is drivers side, rear engine. I disconnected the battery...
Re: OK !
well i removed mine....it wasn't easy until i realized that i didn't need to save the box itself, then it got extremely easy. Its very hard to reach the bolts under the box, so i just used a BFH, or large hammer, and broke the box apart then removed the bottom bolts.
Anyone know exactly what i need to remove to remove the starter on a 307 86 Salon? I think i have blown fusible link not allowing my battery to charge.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.