Recent content by tk76

81-88 are the same.

Finished narrowing my frame rails. Also set up the gears in the rear end.

Better up there rather than rotting in the red necks field behind his trailer! :rofl:

Depending how it was welded. The door skin could be to warped. May cause a problem with the outer door handle. Or you can get a door skin from a junk door cut the handle section out and graft it on to your door.

As long as the muffler is welded together it lasts long. After that its personal choice, unless you are looking for every amount of hp. On ebay there are flomaster 40s knock offs for about $60. Thats for 2 mufflers and I think shipping. I have them on my daily and they sound the same as...

Any plans?

Welcome! Can't wait for pics and questions. Lots of good info here.

X3

Nice first car!!! Welcome abord!

Just make sure it's not a tall deck. Mounts right up to sbc engine mounts. Even the distributor and possibly starter are the same.

Joe Mondello has been dead for about 2 years. His work was excellent, but his business rep has sucked for along time.

Very quick delivery and great with returns also. I recieved parts ordered from Summit which is over 300 miles away that got to me before parts from Napa's warehouse that is 45 minutes away from me. Unfortunatly I'm not exagerating. SUMMIT IS THE BEST!!!!

Agreed !!! I have done this a few times always came out. Just go slow ! You can replace it with a male pipe plug from a hardware store.

First if you don't have a compressor to at least operate a DA you won't have enough consistant air pressure to operate a gun. Second you shouldn't paint over the rustolem. Always take off as many layers as you can. Third read all that you can before hand and take your time, practice first on a...

Welcome! Cool ride you got there!