307

  1. S

    Replacing 307 Water Pump

    I’v tore down almost everything needed so far. What other bolts are there for Power Steering pump. Two on left side of bracket and one on bracket from Alternator? Do I have to pull the pulley off the PS? 85 442
  2. Tillrock

    My new Hurst Project

    Hello there; I have pulled the trigger on an '84 Olds Hurst, that I'm extremely eager to begin. It has the original Olds 307 in it, which runs, but is a bit dirty. Anyways, I've posted a picture below. I think I can handle most of the interior work myself. It's not in bad shape. I realize I need...
  3. W

    1985 Cutlass Original 307 oil dipstick

    I can't Find the engine oil dipstick. Can someone point me in the right direction. I have located the transmission oil dipstick it's on the passenger side right behind the valve cover but I don't see the engine oil dipstick.
  4. oxide80

    CCC Closed loop oddity and questions

    So Ive been messing with the 87 442 off and on through the winter, I had a feeling when I bought it that the car has a few electrical gremlins... Upon purchase the check Engine light was on... I didn't have my dx tools with me, but figured it was nothing major and took a gamble... Found out the...
  5. DaneCLTNC

    Which sensor is what? (Installing triple gauge set)

    So I've bought a triple gauge set and am trying to prep for install. I've got the 307 Y motor in my 86 regal and am having trouble finding correct info. So there are three sensors right close to each other. Trying to figure out which is which. See photo. One has a single tan wire One has a...
  6. DaneCLTNC

    MAT Sensor Location?

    Hi all, first post. I recently purchased a 1986 Buick Regal with the 307 V8. Previous owner said the check engine light has been on for years but never affected the car. I did the paperclip trick and jumped out pins a and b and got two codes, 23 and 45. So im trying to find the MAT sensor...
  7. Christines86Cutty

    New to this..

    I have a 1986 Oldsmobile Cutlass Supreme Brougham, with the 307 5.0 V8 and 4bbl rochester quadrajet carb. I just replaced the cylinder heads and gaskets. It has some issues, but it's mine so I'm trying to figure it out a little at a time. Hopefully I can find some ideas here. I need the air...
    • Christines86Cutty
    • Thread
    • 1986 307 brougham cutlass cutlass supreme oldsmobile quadrajet
    • Replies: 15
    • Forum: New Users
  8. 88cutlass

    Engine turns off while driving

    What's up guys my car recently turned off while at a stop light but i just turned it back on no problem and ran no problem. This the second time it happened, about 4 months ago it happened while making a turn. It's starting to worry me. Car runs fine just turns on pretty weak sometimes. Any...

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom