blower

  1. Dezimade

    MALIBU Blower wire

    Good morning guys: what do you call this end that attaches to the blower motor ? Plastic. As I found this for 14$ with some digging! And where can I find the assortment of these as I may need a few. New at this. Thanks for you patience! Dez
  2. Dezimade

    MALIBU Mystery light/flame

    Hey guys, I have seem to spot a hole, where light, flame, heated coil, I really don’t have any idea. Does anybody have any clarity on why this is like this color Blower motor , 79 Malibu Link of video below. Any clarity would be greatly appreciated!! As I’m not sure what this is ...
  3. Dezimade

    MALIBU Blower motor mystery

    Hi guys. Blower wasn’t blowing found it was that black wire! That said, I noticed on examination a little bright orange light coming from the hole near the plug. Does anybody know what’s underneath there causing this light that is admiting…. I’m fearing it might be a coil or somethings...
  4. S

    BLOWER MOTOR 2 TERMINAL

    Well next question is this. I only find replacement blower motors with ONE terminal. Mine has TWO TERMINALS, one for power I assume and one for ground. Since the housing it sits in is PLASTIC, how would a one terminal motor ground? Don't they also make two terminal blower motors? Anyone...
  5. S

    84 REGAL LIMITED

    Anyone have the fuse block diagram or know what size fuse I should use for the BLOWER FAN? My fan stopped working when it burnt the ground terminal on the BLOWER SPEED MODULE pcb that sits inside the blower housing. I have the automatic climate control system with the soft touch membrane...
  6. S

    HELP! 84 BUICK REGAL LIMITED

    Hi all, my name is Steve. I am new to the forum. I have an '84 Buick Regal Limited as a daily driver with the V6. Today my blower motor fan shut down when I went to turn on the A/C. Again the GROUND wire terminal end on the PCB block (printed circuit assembly board that goes inside the...
  7. E

    81 Malibu Classic Heater Troubles

    Hello, I have a 1981 Malibu Classic that had the 4.3 v6 and upgraded it to a small block 350. I took out all the smog and emmisions. When I did this i still had heat, but it wouldn't switch over from vents to defrost and etc. That was fine, but I would like to know how to fix that. But that's...

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor

Top Bottom