7.5 rear suggestions
- Thread starter SoFloG
- Start date
- Status
An idea
print
b.o.p 10 bolt auburn posi with Richmond ring and pinion and forged - $500 (Whitmore Lake)
condition: excellent
make / manufacturer: Auburn
safety tips
only used during 500 mile engine break in but decided to change my setup so no long need it
was in a 1968 pontiac gto
auburn cone type posi differential
new bearings
Richmond ring and pinion 3.55:1
inland empire driveline forged steel yolk
paid about 1000 in parts
550 obo
must sell
posted: 2016-04-25 11:25pm
email to friend
♥ best of [?]
b.o.p 10 bolt auburn posi with Richmond ring and pinion and forged - $500 (Whitmore Lake)
condition: excellent
make / manufacturer: Auburn
safety tips
only used during 500 mile engine break in but decided to change my setup so no long need it
was in a 1968 pontiac gto
auburn cone type posi differential
new bearings
Richmond ring and pinion 3.55:1
inland empire driveline forged steel yolk
paid about 1000 in parts
550 obo
must sell
- do NOT contact me with unsolicited services or offers
posted: 2016-04-25 11:25pm
email to friend
♥ best of [?]
Lol I don't think I would jb weld those back on. I would just throw them away so it would be lighter which of course means faster.
I know you're against it but I did the 8.8 swap and its great. The rearend is now not even a concern of mine...
$125 complete rearend
$50 clutch kit
$75 new bearings
$260 Instant Center correction kit
$90 brake lines, pads, rotor resurface
-------------------------------
=$600 New readend plus adjustable control arms and rear geometry
$125 complete rearend
$50 clutch kit
$75 new bearings
$260 Instant Center correction kit
$90 brake lines, pads, rotor resurface
-------------------------------
=$600 New readend plus adjustable control arms and rear geometry
it doesn't say in the ad but that 10 bolt would be an 8.2 and I'm surprised that it would be an Auburn and not an Eaton posi
My parts list, for your 7.5
Weld up the axle tubes to the center housing. Moser pn A102801/28 spline, stock length on my elco. Get a 3 series carrier from late 80 s, early 90 s f body, or s 10 axle. (auburn posi preferred) They are 28 spline. There are lots of trailing arm sets available, E-bay, for not a lot of money. 3.08 or higher gears are 26 spline, & 2 series. good luck. P.S. 1 tire hooking, by me is, u burned the spinner.
Weld up the axle tubes to the center housing. Moser pn A102801/28 spline, stock length on my elco. Get a 3 series carrier from late 80 s, early 90 s f body, or s 10 axle. (auburn posi preferred) They are 28 spline. There are lots of trailing arm sets available, E-bay, for not a lot of money. 3.08 or higher gears are 26 spline, & 2 series. good luck. P.S. 1 tire hooking, by me is, u burned the spinner.
- Status
Similar threads
