Anyone have the fuse block diagram or know what size fuse I should use for the BLOWER FAN? My fan stopped working when it burnt the ground terminal on the BLOWER SPEED MODULE pcb that sits inside the blower housing.
I have the automatic climate control system with the soft touch membrane controls.
THIS uses a special module that has many transistors resistors caps etc. on a longer pcb.
I repaired the end of the terminal wire and installed an in-line fuse for protection on the ground. I put in a 10 amp and it blew the fuse after the fan motor started blowing air. Since this is the original fan motor from '84, I think the motor is drawing too much current and is why the ground terminal on module burnt in the first place.
ANY HELP would be appreciated. Thanks
I have the automatic climate control system with the soft touch membrane controls.
THIS uses a special module that has many transistors resistors caps etc. on a longer pcb.
I repaired the end of the terminal wire and installed an in-line fuse for protection on the ground. I put in a 10 amp and it blew the fuse after the fan motor started blowing air. Since this is the original fan motor from '84, I think the motor is drawing too much current and is why the ground terminal on module burnt in the first place.
ANY HELP would be appreciated. Thanks