Jumby version 4.0

[procircuit]

Was an absolute scorcher out today, had to setup both window a/c units to try and keep cool, drilled and tacked the winch plate into place, and made up a front bumper, added supports to it.. More tomorrow

I plan on cutting some out of the centre to add a hawse for front suck down, and I'll likely drill a few speed holes in the plate

All cleaned up and ready to make some fender/hood supports tomorrow,decided to leave full width and cut out just what I need from the fenders..

 

[Kansas Bu Wagon]

I bet those tires will fit in the stock wheel openings lol.

The truck is looking great man, keep it up!!!

 

[procircuit]

I bet those tires will fit in the stock wheel openings lol.

The truck is looking great man, keep it up!!!

ya they might be a little tight lol thanks!




I changed my mind yesterday, decided to narrow the front.. halfway thru i decided to make the front a one piece clip using the factory hinges and ill hood pin it at the front. its all tacked up for now like everything else, i need a few more fenders for donor filler pieces..



obviously still some trimming to do, this is at full bump

 

[procircuit]

Getting work done today, ill post some pics later

 

[1evilregal]

lookin awesome!

 

[procircuit]

Thanks!!

Mounted the steering reservoir right over the pump, cut a hole for easy access thru the hood. Used some plates to make the rear window lower frame removable.. And finished the belly/slider.. Also picked up a new saw, finally cutting things without a zip cut!! It was a bit to low for my tall *ss to work with so I made a cart for it..some trick battery hold downs came in from TMR customs. As well as some other zap strap tabs and panel fasteners

Plans are to sheet the bottom and sides with UHMW

 

[procircuit]

2 Steps back then 10 steps forward? i don't like the rear portion of my chassis.. its bugged me since i did it. so i've removed some and ill see if i can make that work or if i have to go even further back..

 

[liquidh8]

Moving right along, can't wait to see some pics and vids of this beast in action. Nice work as always. 😀

 

[procircuit]

So I finished going backwards and moved ahead finishing the rear tube work again. few more little tie ins and the back should be buttoned up..

Trying different ideas

 

[procircuit]

Where was I now...

my new Radflo 16" 2.5 Coilovers arrived, flexed her around and moved the mounts to compensate for Radflos being slightly longer..

Started front bump bracing

And for some reason forgot to keep going on those,

Put the cab back on to figure out a-pillar and door bars, made a little cut out section (still to be capped) makes getting in an out a breeze.

Bcc whipped me up some hub stands for jumby, work minty. So much room for activities now..

Then stripped her all down, finished off both sides and added dash bar..

That's all till next weekend..[cheers]