Rearend shifted

[pontiacgp]

Yes I had it checked for rust but there was nothing major found and as far the rear alignment we measured from the center point of the car to the rearend and the measurements were the same

I would measure the gap between the frame and rockers on each side

 

[Shellboy12]

I would measure the gap between the frame and rockers on each side

Ok I'll try that!

 

[L92 OLDS]

Ok I'll try that!

Take pics of your measurement and post them here. I’m betting it’s way off

 

[Shellboy12]

Take pics of your measurement and post them here. I’m betting it’s way off

Ok will do but it wont be until tomorrow.

 

[pontiacgp]

Ok will do but it wont be until tomorrow.

and remember these cars are metric so you'll need to measure it in millimeters..... 😎

 

[L92 OLDS]

and remember these cars are metric so you'll need to measure it in millimeters..... 😎

You should also always use a metric crescent wrench on our cars

 

[pontiacgp]

You should also always use a metric crescent wrench on our cars

my left handed crescent wrench is metric and I have a right handed SAE crescent wrench... 😎

 

[39F]

Im thinking probably lil far outside the box here but check your axle tube if it broke the spot welds and rotated that would also let the tire move forward due to the mounts no longer being at the same angles any longer especially a 7.5 rear

 

[Pc3]

my left handed crescent wrench is metric and I have a right handed SAE crescent wrench... 😎

switch hitter?