What did you do at work today?

[Streetbu]

Been building this tool for Microsoft. One of eight were building for them.



Just installed the spinners in the deck with the controllers in the top right hand headcase door.

Ran the outlets and wiring down below using these tabs I made and cut out on our fiber laser. Pop a stud, bolt the tabs down and voila! Convenient location for a zip tie to hold everything in place!

 

[86LK]

Been building this tool for Microsoft. One of eight were building for them. View attachment 216246

Just installed the spinners in the deck with the controllers in the top right hand headcase door.

something to test Window 11 with? 🤣 or is this like, a new m$ product? M$ DJ Clippy?

 

[Streetbu]

something to test Window 11 with? 🤣 or is this like, a new m$ product? M$ DJ Clippy?

Nah, they are for semiconductor fabrication. Not quite as fun as DJ Clippy 🤣

 

[melloelky]

got the auburn ready for primer

 

[08Malibu]

got the auburn ready for primer View attachment 216291View attachment 216292

what primer you putting on there?

 

[melloelky]

what primer you putting on there?

Clausen's all you need.

 

[-dw-]

2014 chev 3500 cube van, rear axle rebuild. Had water in it. All new bearings, seals, ring/pinion, differential and axles.

 

[08Malibu]

Clausen's all you need.

Best poly out tgere

 

[ck80]

Best poly out tgere

Bout $1k/gallon isn't it?

 

[melloelky]

Bout $1k/gallon isn't it?

250 a gallon