What did you do to your g-body today 2025 Edition!

[mclellan83]

Then got terrible pics of me putting the starter heat wrap on

after I got that on I realized my passenger side DRL/turn signal was falling out so had to rezip it back into place, now its a little higher than I want. But going to wait until its on a lift, trying to get my arms under there was a task

 

[old80cs]

Sitting at the alignment shop now, hopefully no more issues to contend with. Nice sunny morning for a drive but rain moving in around lunch time. 😒

 

[85cutty442ttop]

Drive shaft installed. Torque converter bolted to flex plate. Had to drop trans a little to plug in connectors.

 

[Rktpwrd]

G bodies, plural.

Got The Juggernaut spun around so that the tail end is opposite the air compressor, so that I can prime the inside of the tail panel soon and not have the compressor suck in all the overspray.

Nice change of scenery.

Also, the bodywork on the outside of both quarter extensions is now finished and I’m on to the outside of the back panel.

Since it was finally a beautiful warm day here, I then got Olds Cool out of her winter storage for the first time this year. Gave her a much needed bath then went for a nice little cruise.

I was on my best behaviour with her and didn’t even paint any 11’s on the roads today!
So unlike me.
😅

 

[mclellan83]

Took it Friday night to the Tiki Bar to meet some friends for a little over an hour before going to meet my step dad for his bday dinner, apparently the starter heat cover doesn't fix my issue. But just as I was pulling in to parallel park it stalls out when I put it into reverse, and of course wouldn't restart so after a couple of tries I push it in myself as I am ready to light it on fire. Finally as I have it half way into the spot I try again because I need to turn the wheel back the other way and it starts. Boy was I frustrated with it. So then when I get home from dinner I figure I am going to mess with the upper screen cause I hate how it just flops around for the most part. Only solution I had was to glue in a piece of wood for it to sit on and zip tie it to the cage of the head unit, for now it did work and is solid. But if I have to pull it out then I will need to rip the wood out

After Cars N Coffee on the way home it has its saving grace, it can look mighty pretty in some pics