I know enough about NY to know that's one of them NYS compliant fck'd off pistol grips...at least it makes a good boat rudder when you lose it on a fishing trip.
What did you do to your non-G body project today? [2021]
- Thread starter 500/600
- Start date
- Status
That Merc looks pretty meanThe garage tonight, had some fun today
2016 AMG GT S Edition 1, dynoed at 670whp on E85 and 23psi. Let's just say Christmas day was a lot of fun even on the "low" octane tune. 😗
2016 AMG GT S Edition 1, dynoed at 670whp on E85 and 23psi. Let's just say Christmas day was a lot of fun even on the "low" octane tune. 😗
Are those flares stock?
Well, got under my Z06 to clean and inspect it after taking it for a little run through the median..I guess going along the rumble strip on one side and in the grass on the other makes it feel worse than it was, fortunately. Still nice and shiny on top. 😎
Scratches on the front of the cover and something got it on the driver's rocker panel. I can fill that in with paint and try to buff the scratches.
Point of exit off the highway, at least the grass was cut and it was flat. That slope down is where people get into it, over correct, and spin a car out. I just kept it straight and pointed to the highway, back on it and chased that fool down. I was not amused.🤬
Scratches on the front of the cover and something got it on the driver's rocker panel. I can fill that in with paint and try to buff the scratches.
Point of exit off the highway, at least the grass was cut and it was flat. That slope down is where people get into it, over correct, and spin a car out. I just kept it straight and pointed to the highway, back on it and chased that fool down. I was not amused.🤬
Nope. The widebody kit is from Prior Design, bumpers, hood, flares, spoiler, skirts and cannards.
This is the guy that built it, my buddy bought it like this but with the duck butt wing.
That's a bad bish2016 AMG GT S Edition 1, dynoed at 670whp on E85 and 23psi. Let's just say Christmas day was a lot of fun even on the "low" octane tune. 😗
Stained some fresh fence boards for the gate section.
The back side doesn't afford 100% easy access once they're installed. These are a solid 3" wider a pop vs what I have now, so will likely whip out the miter saw to better contour them to the ground to better mitigate critter ingress.
The back side doesn't afford 100% easy access once they're installed. These are a solid 3" wider a pop vs what I have now, so will likely whip out the miter saw to better contour them to the ground to better mitigate critter ingress.
- Status
Similar threads
