Hi all - i have a 2004R late model I drove for 10 years.. tore it down and installed the clutch packs, hardened input shaft and drum, sonnax tv boost kit and valve upgrades up front in the pump, art carr shift kit, sonnax Pinless Accumulator Piston Kit and sonnax servo kit 0.500-
all clutch clearances checked out, i followed chris book for pretty tight clearances for rear, ctr and fwd- (i dont think this is the issue though..)
everytime i accel hard atf hits my pass side header! this is the 2nd time ive put it in - at last teardown there was no smoking gun- super clean inside. band clearance was a little loose so rewelded an got it to 60 thou..
But the same thing happened again for the 2nd time its not coming out of the vent tube, fluid is correct hot-stumped. im thinking sth int he valve body is off or sth is not right there..
Would checking pressure indicate where the issue might be?
all clutch clearances checked out, i followed chris book for pretty tight clearances for rear, ctr and fwd- (i dont think this is the issue though..)
everytime i accel hard atf hits my pass side header! this is the 2nd time ive put it in - at last teardown there was no smoking gun- super clean inside. band clearance was a little loose so rewelded an got it to 60 thou..
But the same thing happened again for the 2nd time its not coming out of the vent tube, fluid is correct hot-stumped. im thinking sth int he valve body is off or sth is not right there..
Would checking pressure indicate where the issue might be?