1954 chevy 210 project

Status
Not open for further replies.
Mike P said:
It looks great!!!

What did you end up doing for a rear end? I wish I had seen this sooner, I would have let you know that a 57 Chevy rear end is a bolt in. It's a drop out center section like a Ford 8"/9" and a good selection of factory gear ratios.....3.08, 3.36, 3.55, 3.73 and 4.11.

That is exactly what I used and it fit ok, but was still to far forward so I had to modify the spring pad on axle.
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor