? To QP Ford 9 owners
- Thread starter Doug Chahoy
- Start date
- Status
did not transfer the bump stops running eibach drop springs.
we never used a gasket, black silicone and copper washers and we never had one leak. An old friend who use to work as Ford said he never used a gasket
I got my center section installed by myself today. With the housing already in. Thank God for a collection of bungee cords . I used 2 to strap on the jack while I moved, positioned, and raised it. My axles finally showed up just as I was bolting the chunk in. Now I have an unfamiliar puzzle to figure out since I’ve never done this before and there’s no directions. There are the 3 pieces that fit on the axles ( in pic ) that i don’t know how or when they go on. I can figure out the seal and bearing, but what about the smaller ring?
All 3 were on the axle in that order, small ring first , seal , then bearing toward the hub. I have no idea where the smaller ring fits in.
Of all the videos I’ve watched, I haven’t seen what I need. I’m thinking after I put the seal in the housing, put my Camaro backing plate loosely on the axle, then the bearing, followed by the smaller ring up against the bearing. Right or wrong?
- Status
