What did you do to your G-Body today? [2011-2018]

[RunAwayNJ]

My wife and I started hand painting the silver trim around the front turn signals and rear lights. My wife's much better at it than I am - I had to mask everything where she has a steadier hand. So she finished that up while I continued to detail the engine.

 

[Alerch]

Finally finished my search for the last 2 pcs of my non ac set up that i was missing. What a tough search....

 

[G_Body_Enthusiast]

I replaced the thermostat with the right temp, 195 degrees, and replaced the temp sensor connector that was broke and had an abraded wire near the connector. Got started late so I didn't get anything else done. More to come in the following days....

 

[79malibu350]

FINALLY, after almost 18 years of dreaming about it, bought myself a 2 in cowl hood from good mark
and tomorrow I'm going to see how much glass tint is gonna set me back

 

[rodneypierce]

Got the drivers side and half the roof wet sanded and buffed today. Here is a sneak peak until I can push it out in the sun tomorrow 🙂

 

[axisg]

well over the winter the wind ripped off my car cover and took my PS mirror with it ! Today I painted the spare with the color match paint that I got mixed up at Napa ( $29cdn ). I must say I was pretty impressed how close the color seems to have matched up. I may have them mix me up a quart and I can spray my spare hood to see how well it looks on a large panel.

 

[gdouaire]

Installed Cadillac Eldorado power seats in my Cutlass. What do you think about the switch location? Not convinced yet.

 

[skulledmonte84]

I got my HAYDEN 3652 Fan Controller,started to install it,but i am confused it's all but hooked up just the green wire.how do i hook it up ? Is anybody else using the kit ? i got questions,it's not working I NEED HELP PM ME

 

[Alerch]

Had a nice surprise when i came home from work... All my UMI suspension was sitting on my porch!!!! Now its time to start ripping the car apart for a full make over 😀

 

[BPTTONE420012]

CHOPPED N WELDED MY CROSSMEMBER FOR DUAL EXHAUST... IT MIGHT NOT BE PRETTY BUT IT'LL HOLD N WORK... I'll paint it tomorrow, its raining out right now...
BEFORE

AFTER