What did you do to your G-Body today? [2019]

[motorheadmike]

Installed the 45° couplers for my intake plenum, then started test fitting.....again! Damn it just clears the fans, but I've got some serious adjusting to do to the plenum tubes. It looks too cool to me to sacrifice for a single plenum.View attachment 110467View attachment 110468

Those couplers look pretty heavy duty... where did you source them?

 

[Injectedcutty]

Those couplers look pretty heavy duty... where did you source them?

Good ole ebay....

http://rover.ebay.com/rover/1/711-5...0001&campid=5335822911&icep_item=301786069269

 

[GroceryGetter83]

Moved this monster into place:


Did you know TH400’s are heavy?! 😅

Bolted into place, need to address crossmember next:

 

[GroceryGetter83]

I will have to figure out the drive gear/driven gear so I can use the stock cluster/speedo with the TH400

 

[Jimmy]

Removed steering gearbox, replaced input shaft seal that was leaking and painted it. Now ready to reinstall.

 

[Pablo’s Buick Garage]

all done the drivers side. Watch it on my YouTube channel! Lol


Sent from my iPhone using Tapatalk

 

[mclellan83]

Very minimal, started on this then got pulled into doing a few other things. At least was able to get her to the first cars n coffee of the year here

 

[RG383Hurst]

Finished up floor shift steering column. Came out of an 87’ Calais. Tilt was all over the place. Took it apart and cleaned it up. Swapped out the 87 switches with new 83’ wiper and blinker switches. Also swapped out the ignition switch and installed the new (to me) wheel.

 

[TURNA]

DAMMMM looks sweet!!!

 

[Wageslave]

I took my S-10 A/C line and the end out of the G-Body line and had a hybrid line made at the local parts store. I now have all the physical pieces installed to have air conditioning this summer. Making everything seal, however...