What Did You Do To Your G-Body Today? [2020]

[motorheadmike]

Ordered a '79 Cutlass assembly manual cause it's the only one out there for our cars. When I get it I might need some of you Olds guys to translate some stuff into english.

This one?

1979 Oldsmobile Assembly Manual Cutlass Reprint

www.faxonautoliterature.com

 

[UC645]

A little silver and a few coats of clear coat later.....

Now I just have to get this conversion u joint installed and my ZQ8 donor driveshaft will be ready to fit.

 

[melloelky]

i pulled the o-ring adapters and hoses from the steering box,brake cleaned it all down.one of the rings was a stretched and had a flat spot(??)i replaced them both and ran it for a while.no leaks so far.maybe that was it who knows.there's a h20 ban here so I'll go to work tomorrow and jack it up and clean the underside of it all.gonna try some foamy see how it works.

and there it is.. 😛

 

[pagrunt]

This one?

1979 Oldsmobile Assembly Manual Cutlass Reprint

www.faxonautoliterature.com

Yep

 

[WanaBa442]

My daughter at local cruising at MalmiView attachment 150838

Anyone else notice the blonde in the background is the only one with a smile.......
Good to see someone appreciates the effort shown here😍

 

[Streetbu]

Took it and the wife for a drive 🤣 stopped for an ice cream.

 

[melloelky]

chased the leak some more,another perfectly good hot rod shirt hits the rag bucket.damn shame..👎🙂

 

[UC645]

Got an idea from a Facebook group to make clear tail lights. Figured out the OE ones are bonded plastic-to-plastic instead of using butyl sealant like the 87-88 lights. So the dremel got to work today

I’m going to use a molding technique used in scale modeling, using epoxy resin to cast the lenses. It’ll set me back a pretty penny to do once, but if I get the molds right I can most likely make these at any point in the future.

 

[Ribbedroof]

Puzzled on the coupe fuel issue. Opened carb again, verified float setting, removed needle clip, checked seat for windows(no windows). Guess it's going to be an electric pump. Or take it apart and sell as a roller (not that anybody has any money around here). either/or at this point, I'm sick of the damn car. Shoulda spent the time on the wagon, which starts and runs fine...just won't go forward.

 

[melloelky]

Puzzled on the coupe fuel issue. Opened carb again, verified float setting, removed needle clip, checked seat for windows(no windows). Guess it's going to be an electric pump. Or take it apart and sell as a roller (not that anybody has any money around here). either/or at this point, I'm sick of the damn car. Shoulda spent the time on the wagon, which starts and runs fine...just won't go forward.

cough wagon project cough cough
😛