84' Cutlass pro touring build

[fleming442]

Did you at least pin it while you were in there?
That 240ft/lb spec is just asinine!

 

[Tony1968]

Did you at least pin it while you were in there?
That 240ft/lb spec is just asinine!

No I didn't. God help me if I ever decide to go that route! Haha
Never say never...

 

[Tony1968]

Done. Very easy installation. Kudos to Holley for a well designed system

 

[scoti]

I here ya. I looked for years for wheels that I liked. Found lots of them. They were also about $1500 EACH and up 😳 Wayyyyy outta my price range. Stumbled across the ones I have for a tenth of that each. Sold!

It's unfortunate the selection drops significantly w/the price (selection = style, size, & fitment options).

 

[scoti]

Done. Very easy installation. Kudos to Holley for a well designed system

Agreed. Holley did well (across the board) w/these new Mid-Mount kits.
Looks close @ the steering pump/reservoir but clears.

 

[melloelky]

clean! looks good Tony

 

[Tony1968]

Agreed. Holley did well (across the board) w/these new Mid-Mount kits.
Looks close @ the steering pump/reservoir but clears.

It is close but just enough clearance.

 

[Tony1968]

 

[Tony1968]

Specs...
Rocket Racing Hyper Attack
18x10 rears with 5.5" backspacing
18x9 fronts with 5" bs.
Ran fronts left to right fully and they clear fine. Going to pop on a fender and check again but I did all measurements with fender on so should be good to go.
Front tires will be Nitto NT05 265 35r18
which are 10.35 wide and I'll have enough clearance
Rear wheels have almost 1 inch clearance to frame and fender so that tire in 295 35r18 which is 11.6 wide will leave me with plenty of room on both sides. Rear is at full droop in pics so wheel looks tiny. Going to get prices on rubber.

 

[scoti]

Nice. Looking forward to seeing it sitting on the ground & weighted.