84' Cutlass pro touring build

Injectedcutty

G body LS mafia
Nov 24, 2014
6,057
22,807
113
Louisville, KY
Decent, I found the spare ferrule thingy...
20200919_102503.jpg
 
  • Like
Reactions: 1 users

Tony1968

Royal Smart Person
Supporting Member
Jul 1, 2018
2,313
5,100
113
NW Indiana
So here i am knee deep.... I am going to get a 2 inch hole using an electrical knockout slug tool behind the intake manifold for wiring harness. Seriously considering removing all the factory insulation and going aftermarket for heat and sound insulation on the firewall. If you were in my position what would you use? I'm not opposed to spending some money here but the choices are so vast it's confusing 😕
20201001_121140.jpg
 
  • Like
Reactions: 3 users

Tony1968

Royal Smart Person
Supporting Member
Jul 1, 2018
2,313
5,100
113
NW Indiana
Slug buster going in. Much safer than using a hole saw especially with what's right on the other side. Clean hole. No burrs and cut like a hot knife through butter
20201001_143754.jpg
20201001_144924.jpg
 
  • Like
  • Winner
Reactions: 12 users

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor