MALIBU Cold 🥶 Start

Status
Not open for further replies.

Dezimade

Master Mechanic
Sep 22, 2021
323
85
28
Boston Ma.
Hi! When the Weather in Boston dips below 60° she has a b*tch of a time
Getting going.


Once she is warm after a choky start 3 minutes perhaps 4 minutes. That sweet
267 small block. Starts to gain momentum. And it’s great.

Where do I begin to fix this issue! Thanks Dez
 

Attachments

  • D961AE2C-8818-4D07-BDC8-5A798559B631.jpeg
    D961AE2C-8818-4D07-BDC8-5A798559B631.jpeg
    866.1 KB · Views: 111
Choke not set correctly, dirty, or carburator could use some cleaning as well... inside the venturies, idle air bleeds(passages) and outside with some carburetor cleaner.
 
  • Like
Reactions: Dezimade
Probably not helpful, but, every gbody, heck, even truck, that I had that was a carb I had to warm it up while parked for a minute or two, giving it *slight* throttle helped speed it up a bit.

Basically, I started it, gave light throttle until the idle went from slight chug/lopey to smooth, then drove. That was every winter in the Berkshires until relocating south.

Not sure if that's what you're experiencing or not, but, it was just a difference between FI and Carb to me. Just chalked it up to winter driving and didn't waste money or fudging settings by the season to alter it
 
  • Like
Reactions: Dezimade
Probably not helpful, but, every gbody, heck, even truck, that I had that was a carb I had to warm it up while parked for a minute or two, giving it *slight* throttle helped speed it up a bit.

Basically, I started it, gave light throttle until the idle went from slight chug/lopey to smooth, then drove. That was every winter in the Berkshires until relocating south.

Not sure if that's what you're experiencing or not, but, it was just a difference between FI and Carb to me. Just chalked it up to winter driving and didn't waste money or fudging settings by the season to alter it
Thanks. That sounds about it.
 
Choke not set correctly, dirty, or carburator could use some cleaning as well... inside the venturies, idle air bleeds(passages) and outside with some carburetor cleaner.
Thanks Ernest!!!
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor