Hey Daddy Warbucks... is your new employer hiring?
Olds ticket to 9s... LS swap adventure.
- Thread starter Northernregal
- Start date
- Status
Hey Daddy Warbucks... is your new employer hiring?
Did I turn fancy? Because this just showed up and I'm gonna use it.
Maven Performance makes a damn fine product.
Maven Performance makes a damn fine product.
Got pretty much all the goodies in hand now. Two of the last big packages showed up today while I was applying 2k epoxy to the hard to reach places on the cage.
The Canadian made 409 stainless 4", I was surprised it was made in Canuckistan.
Then the last order of summit goodies showed up all kinds of wiring, plumbing and weld bungs for every conceivable need. With the very nice summit 4" electric cut out, which i was impressed with.
Got one of them there fancy MSD SSR relay blocks, they seem like the cat's meow these days too.
Gonna be a good week. 😀
The Canadian made 409 stainless 4", I was surprised it was made in Canuckistan.
Then the last order of summit goodies showed up all kinds of wiring, plumbing and weld bungs for every conceivable need. With the very nice summit 4" electric cut out, which i was impressed with.
Got one of them there fancy MSD SSR relay blocks, they seem like the cat's meow these days too.
Gonna be a good week. 😀
Attachments
Looks like a blast, better get bunches of pics.
I've been shopping for a cutout as well. That one looks like it has a smaller profile than most others.
I've been shopping for a cutout as well. That one looks like it has a smaller profile than most others.
Small update, everything seems to be taking me away from the garage lately.
Picked this unit up today and bent my door tubes so I can close the doors with the factory door panels and handles in place, I guess that counts as interior. Other than the pain in the but drilling anchor holes in the floor, yes I know that spot sucks but I don't have a huge garage, it works pretty nicely for a china knockoff. In hindsight I dont think I would buy a pre-bent 10pt cage again, and I am looking forward to making a few other goodies with this bad boy. Tubular front end will be down the road I think.
Picked this unit up today and bent my door tubes so I can close the doors with the factory door panels and handles in place, I guess that counts as interior. Other than the pain in the but drilling anchor holes in the floor, yes I know that spot sucks but I don't have a huge garage, it works pretty nicely for a china knockoff. In hindsight I dont think I would buy a pre-bent 10pt cage again, and I am looking forward to making a few other goodies with this bad boy. Tubular front end will be down the road I think.
Like 3' to bend the 1 5/8" cromoly tube. Its not bad.
- Status
Similar threads
