Ok I'm stumped. What is this connector for? It's not listed in the installation manual and I can find anything that isn't hooked up...
BUILD THREAD Project long time coming
- Thread starter Streetbu
- Start date
The orange wire looks like it is labelled A26. A26 on the 24x/1x LS1 harness is a 5volt. Can you see the other wire numbers? And what part number is your Term X?
Looks like maybe it's for a relay? But why no mention of it at all any where? And for what relay? Fuel pump and fans are turned on elsewhere.... other thing is not all of the wire colors match.
Can you see the remaining number on the wires? If the orange wire is labelled for A26, then it's not for the fuel pump.
There should be an open 'tap' in the harness somewhere - mine has it. Basically a spot for switch 12v, sensor ground, chassis ground and 5 volt. The connector in the 1st picture you attached is the 8 pin additional in's and out's connector, correct? They are located together in the harness I believe.
There should be an open 'tap' in the harness somewhere - mine has it. Basically a spot for switch 12v, sensor ground, chassis ground and 5 volt. The connector in the 1st picture you attached is the 8 pin additional in's and out's connector, correct? They are located together in the harness I believe.
The Original Holley PNP - Flex, Alt, and Combo Harness's
I now have Alternator only / Flex Only in addition to ALT/FLEX combo harness, make sure you choose the right one, read twice, think twice, i will be charging a 15$ restocking fee from today on for returned harnesses. updated overview - https://youtu.be/0KiVve1BBuo100% made in USA This will let...
sloppymechanics-com.myshopify.com
Holley Power-Tap Flex Fuel & Alternator Harness
Direct plug and play sub-harness for Holley terminator and Dominator to connect flex fuel and 4 pin or 2 pin GM Alternator
www.currentperformance.com
That's the power tap - it's coming back to me. The harnesses I attached above plug into it.
I just looked through my manual that came with mine and it's not in there either. I stole my fuel pump wire from that to run the relays in the rear. You should have that along with additional in/out plug inside the car if they aren't there presently IMO. But they can be left outside as well - your decision.
Thank you! Niw that I know what it is,, I don't need it, but it kind of concerns me hanging out in the engine bay open. Wish I could get a plug, for the plug to block it off.
You can. It's a Metripack connector I believe. You can drop probably $30 and get it from Holley or spend a couple of minutes on google and buy one from Amazon $4. If you ask Happel, I'm sure he'll respond with the connector for it.
Similar threads
