Rear end swap ?

[Gonzo1970]

Ring, Pinion, 28 spline auburn-type carrier, Rebuild Kit w/bearings, and strange 28 spline axles.. Around $800

That's what I'm looking at for my rear diff..

-Gonz

 

[pontiacgp]

Ring, Pinion, 28 spline auburn-type carrier, Rebuild Kit w/bearings, and strange 28 spline axles.. Around $800

That's what I'm looking at for my rear diff..

-Gonz

for a few more $$ you can get a 9" set up for a G body, if you ever try to sell the rear end your 9" will retain it's value, with the 7.5 you'll lose even if you can sell it.

 

[Gonzo1970]

for a few more $$ you can get a 9" set up for a G body, if you ever try to sell the rear end your 9" will retain it's value, with the 7.5 you'll lose even if you can sell it.

You guys are so good at spending my money... 😀

-Gonz

 

[pontiacgp]

You guys are so good at spending my money... 😀

-Gonz

maybe you need to get a second job.....🤔

 

[pagrunt]

You guys are so good at spending my money... 😀

-Gonz

 

[Macguyver]

We have a kit to swap about any rear end in to the G Body platform. We even have a kit to do the F Body swap that you mentioned.

 

[wvjaybird]

Thanks for all the advice! I dont have a lot of money left to totally redo the existing rear to make it posi. Think i found a used 10 holt A body rear that has posi 373 gears. Ill get engine and transmission put in and see what i can find or afford. Lol

 

[pontiacgp]

Thanks for all the advice! I dont have a lot of money left to totally redo the existing rear to make it posi. Think i found a used 10 holt A body rear that has posi 373 gears. Ill get engine and transmission put in and see what i can find or afford. Lol

What is the A body rear out of?

 

[wvjaybird]

What is the A body rear out of?

Supposedly out of a late 70's monte carlo . Is there any issues with this rear working in my 86 carlo ?

 

[fleming442]

Will an a-body rearend fit into a g-body?

Hi, I want to verify if an a-body rearend (8.5 rearend) will fit into a 78-87 g-bodied car. I was told that they did, but wanted to be sure. Would...

www.v8buick.com

1973–1977 A-body rear

Found this post on Mailburacing.com, anybody ever try it.http://www.maliburacing.com/forum/viewtopic.php?t=44193from reading the post I think he suggests drilling a mounting hole further in, and that makes the rear fit. I checked and there are two small holes on the upper control arms.

www.montecarloss.com

Too wide- not recommended.