What did you buy for your G body today? [2019]

Status
Not open for further replies.
I overlooked checking the pinion angle after changing the bell housing so the trnasmission sits straight and changing the crossmember plus the rear is stiting a bit higher with the new springs I put in....so to make the job easier I picked up one of these digital angle finders today.... :popcorn:

v_7080_1886-0000.jpg
 
I overlooked checking the pinion angle after changing the bell housing so the trnasmission sits straight and changing the crossmember plus the rear is stiting a bit higher with the new springs I put in....so to make the job easier I picked up one of these digital angle finders today.... :popcorn:

v_7080_1886-0000.jpg
....aaaand you made me watch this and order one
 
Sneak peek.. I’ll a better picture tomorrow once they’re mounted.
DEBCAB31-59A2-4392-9B07-9C0F9BFC33D2.jpeg
 
I went to the yard to buy some wiper arms off of the Cutlass they have. It was raining this morning so that reminded me the passenger arm is floppy with the lock tap loose. I got both arms cause they looked real good and for $20 it's a good deal...plus up here you can never find the right side arm... :popcorn:
 
Ordered a party pulley for the 2+2.

Stock gt500 m122 blower is 3" and it made 8 PSI
I've had a 2.75" for 2 years and I got 11 PSI
The guy I have been buying blower pulleys from for years said he can do one down to 2.55" so in the worst interest of my rods I am getting a 2.55" one. Should get 13 PSI. My power/boost calculations say that that will be good for about 40hp if the blower stays efficient and my IAT's stay low. That means 700ish crank which seems too much.

Now I need to order this t shirt.

1599074584014.png
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor