What did you do to your G-Body today? [2011-2018]

Status
Not open for further replies.
I finally installed my manual steering box....Next step is the 1/4 track this wednesday in Leicester,N.Y. Empire Dragway, to see what times I can get this year..I'm hoping for quicker wuth the muffler, electric fan and manual box upgrades🙂
 
Replaced the ignition switch and took part of the top end of the column apart to see why the steering wheel was loose.... Looks like I need that bearing right under the turn signal switch..... Anyone know where I can find it by itself?
 
joeairforce said:
Replaced the ignition switch and took part of the top end of the column apart to see why the steering wheel was loose.... Looks like I need that bearing right under the turn signal switch..... Anyone know where I can find it by itself?
Make shure you locktight and tighten the four screws that come loose in the lower bowl.
 

Attachments

  • imagesCANCUYLO.jpg
    imagesCANCUYLO.jpg
    4.9 KB · Views: 1,233
Been busy and have not posted in a while, but since my last post I had the new cowl hood painted, got a new exhaust and some new front sneakers.
 

Attachments

  • 100_0787.JPG
    100_0787.JPG
    2.5 MB · Views: 1,222
  • 100_0823.JPG
    100_0823.JPG
    2.7 MB · Views: 1,191
  • 100_0829.JPG
    100_0829.JPG
    2.7 MB · Views: 1,216
JBreu said:
I finally installed my manual steering box....Next step is the 1/4 track this wednesday in Leicester,N.Y. Empire Dragway, to see what times I can get this year..I'm hoping for quicker wuth the muffler, electric fan and manual box upgrades🙂


Any chance of getting a video of that? I would luv to see and hear your car heading down the track...
 
Installed my front inner fender panels, tied back my wire harnesses that have been hanging on the floor since I took out the engine and transmission, cleaned the junk out of it, and pushed it up against the garage wall where it will stay until the end of October when it goes in for body and paint 😀
 
Ordered a front end rebuild kit and upgraded brake parts. Yesterday I found out the distributor weights were stuck and cleaned the heck out of them, I actaully got the timimg set and it ran like a raped ape! Yeah! I think I may have to do something about those 2:56 gears though.
 
Status
Not open for further replies.

GBodyForum is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. Amazon, the Amazon logo, AmazonSupply, and the AmazonSupply logo are trademarks of Amazon.com, Inc. or its affiliates.

Please support GBodyForum Sponsors

Classic Truck Consoles Dixie Restoration Depot UMI Performance

Contact [email protected] for info on becoming a sponsor