What did you do to your non-G body project today? [2020]

[superbon54]

I tried to save the sending unit in the imp today. The 90-0 ohm sender was reading 125-20, which would explain why it would run out of gas at 1/8 tank. In the end, the resistance was still too high and the brittle 25 y.o. plastic made me nervous so I decided to order a new one.

 

[DRIVEN]

I wish you two were a little less depressing.

 

[CopperNick]

Gave it a good car soap and water bath to get most of that damn road salt/slush off the finish.

 

[joesregalproject]

New record, 5 eggs today. I'm no mathematician but I've only got four chickens so I think someone pulled double duty.

 

[Supercharged111]

I grew a set of balls and put a pinion seal in the dually today.

Gonna purge the rear diff, trans, and t case real soon.

 

[L.A.X-RATED]

Muncie rebuild day- the guys at AutoGear said that the relationship between the syncro and cone on the gear is like rings on a cylinder bore. 4th looks glazed to me. I have to press the main shaft apart yet, but this moreorless confirms my suspicion of why it was acting up. Under full throttle, it was fine. It wouldn't come out of gear after a part throttle cruise. I think the syncros were sticking.
View attachment 135679View attachment 135680View attachment 135681View attachment 135682

I have a couple of these in great working cond.low mile 78k.if you need something up and going as so you can complete your rebuild,I'd be willing to barter or take 400.29 SHIPPED.via fastenal.pm me if interested.

 

[L.A.X-RATED]

swapped out my 700r4 on my 94 lac.LIFT? WE DONT NEED NO STINKIN LIFT,WE HAVE HYDROS!!!

 

[1320John$$$]

Putting the water pump on my moms Chevy Cruze as we speak

 

[1320John$$$]

New record, 5 eggs today. I'm no mathematician but I've only got four chickens so I think someone pulled double duty.

View attachment 137114

Wow that’s one horny rooster

 

[FastCraig]

Replaced the cheap azz rear shocks on my Tahoe. Tahoe rides like a new one. The headliner was sagging in several places. I sprayed liberal amounts of 3M aerosol adhesive on the crumbled foam and the headliner material. After about 1 minute to allow the adhesive to get tacky I used a soft brush to smooth the headliner out. I was standing outside the driver's door and was brushing from the middle to the window. It turned out pretty good. I hopped in the driver's seat to press it down more firmly with my hands. It was at that moment I noticed the fabric was about an inceh from the upper door trim. The adhesive was already holding real good so I left it like that. No one will ever know.