What did you buy for your G body today? [2019]

[street sweeper]

Damn, them are good looking seats! Those seats were brought up in the other thread and I see why. I might have to keep an eye out.

I had a cobalt ss previously and loved the seats. So I always had an eye out for them and last week found a guy locally parting out a car and got them for a decent price. Will have to figure out how to mount them and have the driver seat back redone.

 

[Injectedcutty]

I had a cobalt ss previously and loved the seats. So I always had an eye out for them and last week found a guy locally parting out a car and got them for a decent price. Will have to figure out how to mount them and have the driver seat back redone.

Nice score, keep us all posted on what mods are needed to mount them if you don't mind.

 

[street sweeper]

Nice score, keep us all posted on what mods are needed to mount them if you don't mind.

It has been done a couple times. A few pics I found on another forum

 

[mclellan83]

Finally pulled the trigger on my speakers, gonna be getting an 800.4 Sound Digital amp to run them

 

[shawn1112]

Grill and headlight bezels showed up for my 87 header swap on my Regal.

 

[Injectedcutty]

Went to my favorite Oreilly where the guy know me and went radiator hose shopping. I picked two that matched close to my coat hanger mockup lines. I'll test fit in a bit and report back since I'm doing an LS dual pass radiator.

 

[Wageslave]

Bought a set of relays and relay sockets for my injectors and fuel pump relay.

 

[Injectedcutty]

Alright, after test fitting the hoses I'm super pleased with the upper one. It fits and looks perfect. However, the lower one has too big of an ID on the water pump side. If I trimmed the other end it would fit perfect, but there is a 1/8" gap around the thermostat housing...I think that's too much for a clamp to grab it securely. For some reason my new phone won't attach pics on here which sucks until I figure that out.

Upper hose PN: Gates 23460

 

[500/600]

Rear seat braces, 32mm front sway bar and bushings, front frame braces, core support braces.

Now if I can just find the right core support to fender braces.

 

[Rktpwrd]

Alright, after test fitting the hoses I'm super pleased with the upper one. It fits and looks perfect. However, the lower one has too big of an ID on the water pump side. If I trimmed the other end it would fit perfect, but there is a 1/8" gap around the thermostat housing...I think that's too much for a clamp to grab it securely. For some reason my new phone won't attach pics on here which sucks until I figure that out.

Upper hose PN: Gates 23460

Since Scott is having troubles posting pics up from his new phone, I’ll help him out.

Here’s his pics:

That upper fits like a glove Scott!!