What did you do to your G-Body today? [2011-2018]

[MrSony]

I've been looking around for steel braided lines for my blazer rear disc swap, and found that Rockauto is the cheepest by far; It's only $50 canadian for the two lines. Thing is they don't have any listed for our cars, but the camaro uses the same 10mm banjo fiting as our cars do.
https://www.rockauto.com/en/catalog...1361450,brake+&+wheel+hub,hydraulic+hose,1792

neat

 

[pontiacgp]

neat

I read your post about the GPS drag racer app, I have never heard of that app so I downloaded it to my phone and I'll let you know how my Jeep does. I bet my time will make you feel real good about yours...😀

 

[timo22]

Got my dash bezel for the bonneville all wrapped up. The wood grain had to go. At first I was thinking turn motor, then brushed silver and finally put this on..What do you guys think? timo22

 

[Injectedcutty]

View attachment 80167 View attachment 80168 Got my dash bezel for the bonneville all wrapped up. The wood grain had to go. At first I was thinking turn motor, then brushed silver and finally put this on..What do you guys think? timo22

Tim, I think it looks sweet! I am a fan of carbon fiber though, so my opinions are somewhat skewed lol....

 

[motorheadmike]

Tim, I think it looks sweet! I am a fan of carbon fiber though, so my opinions are somewhat skewed lol....View attachment 80169

How ironic. I was just looking into CF and epoxy - got a recommended source?

 

[pagrunt]

View attachment 80167 View attachment 80168 Got my dash bezel for the bonneville all wrapped up. The wood grain had to go. At first I was thinking turn motor, then brushed silver and finally put this on..What do you guys think? timo22

Very nice.

 

[Texas82GP]

View attachment 80167 View attachment 80168 Got my dash bezel for the bonneville all wrapped up. The wood grain had to go. At first I was thinking turn motor, then brushed silver and finally put this on..What do you guys think? timo22

That looks awesome Tim! How did you cut the material to fit? Did you make patterns?

 

[Injectedcutty]

How ironic. I was just looking into CF and epoxy - got a recommended source?

Not sure Mike. I got a sheet of real CF off ebay years ago that had the UV resistant clearcoat, and adhesive backing. I don't recall the source, but will need more soon as I'm almost out of it.
There is a company called dragonplate that has some options, and a composite company that sells all the stuff to DIY. If I can find their site I'll PM you.

 

[Injectedcutty]

Got me a few LED's delivered today for rear lighting. I still need to get some turn/brake bulbs, but those get installed after the taillight housings are bolted on.

 

[85grandprix]

Added tint to the windows of my 1980 Malibu View attachment 79661

gorgeous