What did you do to your G-Body today? [2019]

[DSPbuilt]

Forgot to post this last night.
Gave the block and pistons a quick clean up. Tomorrow I’ll be picking up a puller for the balancer and I can finally start to do the cam swap and begin to assemble this thing.

 

[Cauterize]

aw sh*t. was hoping it'd actually be a nice piece.

So was I! thats why I was fine with waiting for it for so long. It was back-ordered for about 6 weeks

The wife took the die grinder to the header panel and got the headlight adjusters cut in as well as the retention springs. She killed it. For some reason she loves tedious crap like that. Lucky me, and she's damn good at it. I topped off the trans up with ATF, replaced a burnt plug wire and fixed some wiring on the core support that was beyond sketchy.

 

[fleming442]

The wife took the die grinder to the header panel and got the headlight adjusters cut in as well as the retention springs. She killed it. For some reason she loves tedious crap like that. Lucky me, and she's damn good at it.

I soooooo need one of those!!!!

 

[Red78Calais4speed]

Pulled my 1979 Hurst/Olds out of the garage for the first time since April and finally put the correct carb (#17059253) on. Had it rebuilt back in April but never got around to doing it. I should have done it months ago and it's an easy job except for the vacuum lines. I hate them. The 1969 vintage Olds 350 runs good and strong but it's running very rich. Will have to make some adjustments to get it right.


All my "seat" time this year has been spent in my 1978 Delta 88 Holiday coupe.
The old carb can be seen on the table at the bottom of picture 4.

 

[500/600]

Changed my hood ornament.

From this

To this

 

[Texas82GP]

Pulled my 1979 Hurst/Olds out of the garage for the first time since April and finally put the correct carb (#17059253) on. Had it rebuilt back in April but never got around to doing it. I should have done it months ago and it's an easy job except for the vacuum lines. I hate them. The 1969 vintage Olds 350 runs good and strong but it's running very rich. Will have to make some adjustments to get it right.
View attachment 124461View attachment 124462View attachment 124463View attachment 124464

All my "seat" time this year has been spent in my 1978 Delta 88 Holiday coupe.
The old carb can be seen on the table at the bottom of picture 4.

Love the big girl!

 

[1320John$$$]

Finished the stock 87SS to 88 luxury sport exhaust swap

 

[Injectedcutty]

Used the tub, and some SEM soap to clean the upper sail panel trim. These things were nasty, but ready for wipe down and paint next nice day I have time.

Does anybody know if the seals on the backside around the quarter window are available??

 

[Texas82GP]

Used the tub, and some SEM soap to clean the upper sail panel trim. These things were nasty, but ready for wipe down and paint next nice day I have time.View attachment 124663View attachment 124664
Does anybody know if the seals on the backside around the quarter window are available??View attachment 124665

I was planning to just match up some foam tape insulation at the Home Depot. Looking forward to hearing feedback from others.

 

[CaliWagon83]

Installed a new window motor on the driver’s side with my father-in-law. What a difference! 👍