What Did You Do To Your G-Body Today? [2020]

[MrSony]

primed and freeze plugs installed.
took front accessories off of exploded engine. love me them slip on buick balancers. f*ck buying 2 tools.

 

[Injectedcutty]

Moar wiring! I'm battling through the flu, but was feeling good enough to get these gauges wired up. All of the pigtails are made, just have to connect into the car wiring which will be more fun with the dash in. Also got the firewall grommet in(used to be for the ECM wiring on the 307), have the wideband sensor plug, and gauge sensor wiring there. Hope to get more done this week, all depends on how I feel.

 

[Northernregal]

Moar wiring! I'm battling through the flu, but was feeling good enough to get these gauges wired up. All of the pigtails are made, just have to connect into the car wiring which will be more fun with the dash in. Also got the firewall grommet in(used to be for the ECM wiring on the 307), have the wideband sensor plug, and gauge sensor wiring there. Hope to get more done this week, all depends on how I feel. View attachment 137871 View attachment 137872

Where did you get the grommet from the factory computer wiring hole? I likey.

 

[Injectedcutty]

Where did you get the grommet from the factory computer wiring hole? I likey.

It was stock on my car since the old 307 had the computer controlled quadrajunk on it.

 

[sixty7rs]

Shot some clear on the taillights today

Before;

after

 

[jadigen]

i put a 442 rear sway bar on my cutlass today. what a difference it made. i ordered nee end links and bushings and will be installing the 442 front sway bar on my cutlass tomorrow if it doesn't rain..

 

[MalibuDavyou5]

With this cold wind weather I tried to get at the bolt on the bracket holding the starter up, Big fail . Weather doesn't help any.

 

[5spdCab]

With this cold wind weather I tried to get at the bolt on the bracket holding the starter up, Big fail . Weather doesn't help any.

Welcome MalibuDavyou5 from Seattle,-ish Washington.

 

[Injectedcutty]

Just finished installing the wideband O2 bung clamp. Took a little more work than expected, but it's mounted, o2 is at good angle, wiring is tucked up away from heat.

 

[matyor]

Changed the oil and filter, and then gave it a good wash.