Holley pro 850?

[Bri guy]

The load spreaders aren't necessary if you take a few minutes to make sure the holes are flat, and don't go-go-gorilla tighten the crap out of them. I usually put a thin coat of RTV in cork gaskets, too.

I got the rubber gasket. I will inspect them once there off. Why can't I post pics here anymore? I also have to use YouTube to do that?

 

[fleming442]

The Samsung browser doesn't play nice with the site software- use Chrome to post pics.

 

[Bri guy]

Got it to work

 

[fleming442]

That looks like an impressive 403 build- should run it's *ss off. I must have missed the cam specs.......
Edit: found E-brock Performer cam= puny. I'd shoot an email to Rocket Racing with the specs off the invoice, and see what John comes up with. A cam would wake it up, then the 650 would be too small.

 

[Bri guy]

The only info I have on the cam is in the screen shot. Performer rpm cam.

 

[fleming442]

The only info I have on the cam is in the screen shot. Performer rpm cam.

I swear I don't see it. I found that in an earlier post.

 

[Bri guy]

I swear I don't see it. I found that in an earlier post.

 

[fleming442]

My bad, I was looking at the invoice..... Call John at Rocket Racing.

 

[Bri guy]

Not sure why it wasn't on the parts list. But that's what the previous owner had them put in. The dealership I bought the car from didn't know anything about it. Luckily the previous owners name was on the title and I looked him up on Facebook. He gave me all the info. Motor build, parts he replaced or stuff that should be replaced. What he's done to it. Everything I could think to ask, he told me

 

[Bri guy]

That looks like an impressive 403 build- should run it's *ss off. I must have missed the cam specs.......
Edit: found E-brock Performer cam= puny. I'd shoot an email to Rocket Racing with the specs off the invoice, and see what John comes up with. A cam would wake it up, then the 650 would be too small.

Damn. I Just read this.....i will see what he says.