What Did You Do To Your G-Body Today? [2020]

[mclellan83]

Out with the old:
View attachment 153278

And in with the new:
View attachment 153277

I got it started and it runs fairly well, although it is a little lean at idle. I'm not sure if I got all the vacuum hookups correct, as this thing has more vacuum ports than I have friends and there isn't a good port diagram anywhere for this thing.

I also installed a more DOT friendly set of headlights for the somewhat focused low beams. The high beams (right) will be replaced with another set of these if they prove out good. View attachment 153279

I am looking into these again for the Blazer to replace what it came with, I talked with The Retrofit Source and they say that they will have a 3.0 version coming out in the next few weeks. I was saying I would like a DRL in the setup as well, I had been looking at these on Ebay since they have the DRL and even a turnsignal built into them. The other one's I had been kicking around were like this

 

[Wageslave]

She's dead Jim. It turns out that it was 2 quarts low on fluid, and after adding the fluid in there was no change. I have a Turbo 350 in the corner of the garage that may go in after the broken kickdown cable is replaced. Not ideal, but it is prime driving season and it would suck to leave it parked.

I would rather go ahead and put a 200-4r in, but those are proving hard to find around here. The nearest one I can get with a warranty is 3.5 hours away. Choices choices.

 

[fleming442]

Mutha mufukkin' Natcha got the Pig with a big @$$ branch. and gave me 2 nice dents in the roof. Dammit, man!

 

[UC645]

The snowball effect hit me like an avalanche.
Went from this

To this

Have I mentioned how much I hate seam sealer? And I still have more to do.

 

[UC645]

Looks like 2 years ago:

I’ve hit the spots on the upper left hand side with everything except a sand blaster and it still looks like this

I might have to make a spot blaster later. Although I really don’t want to start blasting again- I’m still finding sand in places I didn’t think it could reach.

 

[Texas82GP]

Mutha mufukkin' Natcha got the Pig with a big @$$ branch. and gave me 2 nice dents in the roof. Dammit, man!
View attachment 153357View attachment 153358

Too deep for paintless?

 

[Wageslave]

Mutha mufukkin' Natcha got the Pig with a big @$$ branch. and gave me 2 nice dents in the roof. Dammit, man!
View attachment 153357View attachment 153358

Keep going like that and I'm going to have the prettier Bonneville.

 

[fleming442]

Too deep for paintless?

Dunno . Not gonna sweat it. I have another one to build.

 

[pagrunt]

Looks like 2 years ago:
View attachment 153380

I’ve hit the spots on the upper left hand side with everything except a sand blaster and it still looks like this
View attachment 153381
I might have to make a spot blaster later. Although I really don’t want to start blasting again- I’m still finding sand in places I didn’t think it could reach.

It could be worst, cutting it out...oh, wait you will be helping to do that on a Saturday in the near future. 😛

 

[UC645]

It could be worst, cutting it out...oh, wait you will be helping to do that on a Saturday in the near future. 😛

What you’re having done will require far less precision and far more Mike Finnegan vs Roadkill muscle truck and super swampers 🤣