What Did You Do To Your G-Body Today? [2022]

[Tomicamino]

Christmas came little early this year, pity we have over one feet snow outside

 

[mclellan83]

If she’s whacking the shaft with a hammer and another piece or wood, you’re into the kind of stuff you’d need to pay a subscription for.

Don't you kink shame him, hahaha

 

[UC645]

so getting it for free is a good thing?

 

[RegalX78]

36mm sway bar is back from powdercoat. 14.8 lbs vs the 16.9lb stock 28mm bar.

 

[MrSony]

since gbp dropped the ball on the antenna nut, i bought one off ebay. fits.

 

[Bar50]

I guess I need to update my Christmas list.... a roots superchager and twin Fitechs!!?!

Perfect

 

[SS_Malibu]

I guess I need to update my Christmas list.... a roots superchager and twin Fitechs!!?!

Perfect

You might need to sit on Santa's lap for that.

 

[Bar50]

You might need to sit on Santa's lap for that.

Totally worth it

 

[old80cs]

Worked on the '80 for the better part of 5 hours today. Made up the two tailpipes, the driver side is essentially done and the passenger side is tacked but needs to come apart for some adjustment, cut the outlet pipe and adjust the exit angle under the rear quarter. Will be reworking the hanger behind the muffler (driver side) and lengthening it down to the elbow to give it some room to move. The small bracket I made seems too rigid after I installed and tightened everything. Not a master fabricator by any stretch of my imagination. It's coming along pretty well and am a good bit ahead on total cost involved by doing it myself with the DIY kit. The pit lift has been a nice acquisition and helpful doing this job. A four post would be better but I don't have the ceiling height.

 

[old80cs]

Finished my new exhaust system this morning, first start. There was quite a bit of cold smoke but in its defense it was 25 degrees out when I started it up with the garage doors open. I'm happy with the deep tone of the Turbo-Pro's they seem even quieter than the Thrush turbo mufflers I replaced.