BUILD THREAD 87 Cutlass EFI build: 9/13/23..NEW STUFF!

[Northernregal]

Very nice! Which engine mounts were you using again? Just so I don’t have to spend an hour drooling through your build again. 😉

If I measured correctly it should have a little room to spare. The stealthram that was on the old engine was 10.25" tall. The mid rise is 10.44".

This is back in my build thread, but here ya go....View attachment 79252

 

[Injectedcutty]

Very nice! Which engine mounts were you using again? Just so I don’t have to spend an hour drooling through your build again. 😉

I'm using ICT billet swap plates with factory clamshells.

 

[Northernregal]

Last silly question I promise. How much taller is that intake than a stock LS intake?!?

I'm using ICT billet swap plates with factory clamshells.

 

[Injectedcutty]

Last silly question I promise. How much taller is that intake than a stock LS intake?!?

No silly question man, doesn't bother me a bit. Honestly, I'm not sure how much taller than a truck intake....I'd have to measure my truck intake to be certain. Off the top of my head I would say around 2-3" taller.

 

[Northernregal]

Awesome.

Cue maniacal laughter.

That means a CTSV Blower will fit.

😀 😀 😀

No silly question man, doesn't bother me a bit. Honestly, I'm not sure how much taller than a truck intake....I'd have to measure my truck intake to be certain. Off the top of my head I would say around 2-3" taller.

 

[Injectedcutty]

Awesome.

Cue maniacal laughter.

That means a CTSV Blower will fit.

😀 😀 😀

You can make anything fit as long as you have some tools of persuasion 😉.

 

[Texas82GP]

Awesome.

Cue maniacal laughter.

That means a CTSV Blower will fit.

😀 😀 😀

I'm guessing you noticed the cowl hood in his avatar?

 

[Northernregal]

I'm guessing you noticed the cowl hood in his avatar?

Yup. The LSA blower is a big unit. Kinda figured it would need a cowl, at least I won’t need a redonkulous cowl if I go that way.

 

[Injectedcutty]

Yup. The LSA blower is a big unit. Kinda figured it would need a cowl, at least I won’t need a redonkulous cowl if I go that way.

The cowl hood I have is fiberglass and the cowl is open allowing a good amount of space to "hide" some goodies lol!

 

[MrSony]

Neato!