What Did You Do To Your G-Body Today? [2022]

[Ernest]

I decided to go with AN fittings from the mechanical fuel pump(old one shown) to the carburator and work my way up, not installed yet till i get the other peices needed for final assembly.

 

[SS_Malibu]

I decided to go with AN fittings from the mechanical fuel pump(old one shown) to the carburator and work my way up, not installed yet till i get the other peices needed for final assembly.

I did the same thing when I put in the motor

 

[Injectedcutty]

Got both rear backing plates fabbed up and mounted for the LS1 brakes. Picked up a piece of nicopp to make new lines since stainless are a pita to cut/reflare.
After a bit of fanangling I got the driver side mounted where it needs to be. I'll screw with the pass side tomorrow....

 

[Injectedcutty]

Pass side brake line was copied from the stainless one, and installed. Pics are crappy. Next I'll move onto the e brake brackets.

 

[Rktpwrd]

Pass side brake line was copied from the stainless one, and installed. Pics are crappy. Next I'll move onto the e brake brackets. View attachment 212767 View attachment 212768

Now if only you had a build thread to post these updates on!
Oh wait….
🤣

 

[Northernregal]

Now if only you had a build thread to post these updates on!
Oh wait….
🤣

well played sir...

 

[64nailhead]

Took my SS out to Walmart for some stuff to look high class.

You’re really working your car hard(to make you look good).


Haha

 

[64nailhead]

Fortunately the wrap covers some of the fine welding

 

[Built6spdMCSS]

You’re really working your car hard(to make you look good).


Haha

It's a lot to burden..

 

[MrSony]

Messed with the p/s pump. Disassembled, primed, painted, reassembled with new o-rings. Still works, I think/hope it doesnt leak. Drove it to the gas station, checked for leaks, none yet.
Installed new jugs from Mike's Montes. Very annoyed all but my antenna nut showed up from GBP. I got the ****ing bezel, woohoo, but no nut. Even though i purchased the nut/bezel combo. I also elected to keep the stock washer cap. New one looks too generic imo. Gotta repaint the letters tho.